Copyright Planika Sp. z o.o.
www.planikafires.com
IG0150#05
29.06.2020
17
4.3.
Remote control (if delivered)
GaLiO Fire Pit Insert can be operated by radio remote control. This comprises a hand-held transmitter and a receiver.
The receiver is part of the gas control block assembly.
•
Electrical connections and batteries:
o
Hand-held transmitter: 2x 1.5V AAA battery
o
Receiver: 4x1.5V AA battery or 6 VDC
•
WARNING!
Without using a mains adapter, battery replacement is recommended at the beginning of each
heating season. Old or dead batteries should be removed immediately. If left in the unit the batteries can
overheat, leak, and / or explode. Do NOT expose batteries (including during storage) to direct sunlight,
excessive heat, fire, moisture, or severe impact. Each of these conditions can cause the batteries to overheat,
leak, and / or explode. Batteries must be kept within their recommended temperature limits. Ambient battery
temperature range: 32 °F to 131 °F[0 °C to 55 °C].
•
The hand-held transmitter batteries have a service life of approx. one year. We recommend you use alkaline
batteries. Rechargeable batteries are not permitted.
•
To replace batteries:
o
Open the cover on the back of the remote control.
o
Remove the batteries from the battery compartment.
o
Place two new 1.5V batteries (LR03 or AAA type) as indicated in the battery compartment.
o
Close the cover
4.3.1.
Switch the Fire ON and OFF
Before operating make sure MANUAL knob on the GV60 valve is in the
ON
, full counter clockwise position.
WARNING!
When the pilot light is ignited, the motor turns automatically to maximum flame height. If the pilot flame
goes out for any reason, wait for 5 minutes before attempting to re-light it. If the pilot does not stay lit after several
tries, turn the main valve knob to
OFF.
1.
Open the valve of the gas cylinder (or gas supply
valve in the gas pipe).
2.
Press
button until two short beeps confirms
the start sequence has begun; release button.
3.
Main gas flows once pilot ignition is confirmed.
4.
Handset automatically goes into Manual Mode
after main burner ignition.
5.
Press and hold
button to turn
OFF
the fire.
