Copyright Planika Sp. z o.o.
www.planikafires.com
IG0150#05
29.06.2020
18
•
This can take few seconds to ignite to pilot flame especially when you have replaced and installed a new LPG gas
cylinder.
•
If the pilot light does not ignite after 3 ignition attempts close the gas tap and warn the fitter.
•
Once the pilot light is burning, the main burner must ignite within 10 seconds automatically. If this does not
happen, immediately close the gas tap and warn the fitter.
•
If the main burner ignites with a pop immediately close the gas tap and warn the fitter.
•
If the appliance is not to be used for some time, please close the gas supply valve in the gas pipe (or valve of the
gas cylinder).
•
WARNING!
If the pilot flame goes out for any reason wait for 5 minutes before attempting to re-light it.
WARNING!!!
•
Under conditions of increased humidity (rain, breeze, fog, dew, etc.),
there may be some temporary problems with switching on the fireplace.
This is a normal phenomenon associated with the dampening of the
ignition element.
•
Before switching on the fireplace, wait until the ignition element has dried
completely.
•
You can speed up this process by blowing the pilot flame with compressed
air to remove the accumulated moisture. The properly fired pilot flame
consist of 3 smaller parts.
4.3.2.
Stand-by mode (Pilot flame)
Press and hold
„
-
“
button to set appliance to
pilot flame. Pilot flame remains burning (standby
position).
