User’s Manual of WGR-500-4P and WGR-500-4PV
20
■
Terminal Block Connector Pinout
To install the 3-pin Terminal Block Connector on the industrial wall-mount Gigabit router, simply follow the following
steps:
Step 1:
Insert positive DC power wire into
V+
, negative DC power wire into
V-
, and grounding wire into
Ground
as
shown in
Figure 2-9
.
Figure 2-9:
Terminal Block Connector
Step 2:
Tighten the wire-clamp screws for preventing the wires from loosening and plug them into the industrial
wall-mount Gigabit router
1. The wire gauge for the terminal block should be in the range of 12 ~ 24 AWG.
2. When performing any of the procedures like inserting the wires or tightening the wire-clamp screws,
make sure the power is OFF to prevent from getting an electric shock.
■
DC Power Jack
The WGR-500-4P and WGR-500-4P come with DC 48V~56V power input. The DC power jack is shown in
Figure
2-10
. If you have the issue of power connection, please contact your local sales representative.
Figure 2-10:
DC Power Jack
