User’s Manual of FSD-804PS
The following is the summary table of Reset button functions:
Reset Button Pressed and Released
Function
About
1 second
Reboot the PoE Injector Hub
Until the
SYS
LED lit
off
Reset the PoE Switch to Factory Default configuration. The
PoE Switch will reboot and load the default IP settings as
below:
。
Default Password:
admin
。
Default IP address:
192.168.0.100
。
Subnet mask:
255.255.255.0
。
Default Gateway:
192.168.0.254
2.1.1 LED indicators
■
System
LED
Color
Function
PWR
Green
Lights to indicate that the PoE Switch has power.
■
Per 10/100Mbps port
LED
Color
Function
PoE in-use
Green
Lights to indicate the port is providing 48VDC in-line power. (1-4 ports)
LNK/ACT
Green
Lit: indicate the link through that port is successfully established.
Blinks to indicate that the Switch is actively sending or receiving data over that port.
1. Press the RESET button once. The Switch will reboot automatically.
2. Press the RESET button for 5 seconds. The Switch will back to the factory default mode; the
entire configuration will be erased.
2.2 Rear Panel
The rear panel of the FSD-804PS indicates an AC inlet power socket, which accepts input power from 100 to 240VAC,
50-60Hz. And have a fan hole on the rear panel.
Figure 2-3
FSD-804PS Switch rear panel
Power Notice:
1.
The device is a power-required device, it means, it will not work till it is powered. If your networks
should active all the time, please consider using UPS (Uninterrupted Power Supply) for your device.
It will prevent you from network data loss or network downtime.
2.
In some area, installing a surge suppression device may also help to protect your FSD-804PS
from being damaged by unregulated surge or current to the FSD-804PS or the power adapter.
- 10 -
