PLANETlENW-350-FC
32
Figure 6-3.8 Select I/O Port
6.4 Manual Installation
In most cases, the INSTALL program can make all system changes
necessary for using your
ENW-3502-FC
. But in some cases, you may
wish to make the change manually. This section explains the driver and
file modifications needed to enable your
ENW-3502-FC
.
6.4.1 Enablers
The
ENW-3502-FC
can be enabled by either a Card Services client
driver, CARDGO.EXE, or a direct enabler, ENABLER.EXE.
CARDGO.EXE
The Card Service client driver, CARDGO.EXE, communicates with the
CardBus controller of your computer. This program is needed only for
DOS and Windows 3.1 systems. You should install the CardBus Socket
and Card Services to your notebook before executing the client driver. If
you do not have the Socket and Card Services program, please contact
your notebook vendor.
The INSTALL program will automatically add a line to your
CONFIG.SYS file using the following syntax and format:
DEVICE=[path_name]CARDGO.EXE [/INT=xx] [/PORT=xxxx][/U][/?]
where :
[/INT=xx]
Specifies the hardware interrupt (IRQ)
where your card will be indicated. Default
value is 5.
The valid IRQs are 3,4,5,6,9,10,11,12,15.
[/PORT=xxxx]
Specifies the I/O address. Default value is
PLANET ENW-3502-FC 10/100 Ethernet Card Installation Program
SELECT I/O PORT
Please select the I/O Port that you would like your CardBus 10/100Mbps
Ethernet Card to use.
Use the arrow key to highlight the desired value. When a value is highlighted
press <Enter> to select it.
D000H
D400H
D800H
E000H
E400H
E800H
