PLANETlENW-350-FC
26
6.2.1 Driver Installation Program
INSTALL.EXE is the
ENW-3502-FC
driver installation program. The
INSTALL.EXE program allows you to do auto configuration where the
program automatically selects the most suitable option settings, or do a
custom configuration where you individually select each option setting.
6.2.2 Quick Installation
This section gives a brief overview of the installation process. (For a
clearer step-by-step procedure, refer to the next section.)
1.
If the Card and Socket Services software is included as part of
your computer, it is recommended that you use this software when
installing your
ENW-3502-FC
.
A system with Card and Socket Services installed allows the
PCMCIA card to automatically configure itself. While the system is
on, available system resources and insertion or removal of the
card will automatically be detected.
2. Run the INSTALL.EXE program found on your Installation Disk.
The install program guides you through the installation process
and will install the network drivers needed to run the card on your
network operating system.
If you successfully completed the installation, jump to step 5. If
installation was unsuccessful, then go on to next step.
3. If you are using Card and Socket Services, it is necessary to use
the Card Service client driver, CARDGO.EXE, found on your
Installation Disk. You can install the client driver by typing
CARDGO
at the DOS prompt or including it as a line in your
CONFIG.SYS or AUTOEXEC.BAT file. When installing the client
driver, it is important to note that the driver should be loaded after
Card and Socket Services are loaded.
4. If you do not have Card and Socket Services or if your card does
not work with your version of Card and Socket Services, use the
direct enabler, ENABLER.EXE, to enable the CardBus controller.
The direct enabler communicates directly with the CardBus
controller on your system. Most popular controllers are supported.
To run the direct enabler, type
ENABLER
at the DOS prompt or
include it as a line in your AUTOEXEC.BAT file.
5. Turn off your computer and insert the
ENW-3502-FC
into the
PCMCIA socket. The card is keyed to go in one way only. Then
attach the network cable to the card.
6. Now turn your computer on and connect to your network. If you
cannot connect to the network, refer to the Appendix B and C.
