2 Mega-pixel PoE Plus Speed Dome IP Camera
ICA-E6260
116
Motion
: You may trigger the event if one or many Motion Detection regions encounter a
motion trigger. Trigger from any of them will initiate the event. The duration of event will be
the same as the MD trigger length, or the Trigger interval time, defined in the Motion
Detection section on Video Adjust page. In the example below, Motion Detection region 1 is
used as the event trigger.
You may also ask the event to be repeatedly triggered during this scheduled time. The
interval is determined in minutes. You may use this with email / FTP upload to take
snapshots at regular intervals.
Sound Detection
: The event may be triggered when sound is detected. This feature is
available on cameras with Audio in capabilities only. The Sound Detection must be
configured first to use this feature.
Switch to Night mode
: This is available to selected models only. When camera changes
between day and night modes, the embedded event handler will notice this change, and may
act upon this information.
Potential uses include changing the motion detection profile to another set of Event MD
parameters. By having two sets of parameters each optimized for day and night, this provide
better overall accuracy in both day and night conditions. Some night time only MD regions
may also be activated this way. The event period will end when the camera returns to day
mode, which will then reset the camera to the original settings.
Device boots successfully
: This will trigger the event responses once the device boots up.
You can use this to create a notification system that keeps record of when the device has
been rebooted via email.
Reboot device
: This triggers the event response when the device is shut down via web UI
“Save and Reboot”. Use this to keep record of when was the device setting edited. Note that
this will not take effect when the device is unplugged, as this is not normal shutdown.
Fail to write storage
(with storage card only): Trigger occurs when there is an error in
writing data to the memory card.
Remove storage media
(with storage card only): Trigger occurs when the memory card is