Planar UltraLux Series, Руководство по установке, Страница: 49 / 87

Planar UltraLux Remote Monitoring
Planar UltraLux Series Installation Guide 49
Custom Commands Setup
The Custom Commands Setup page allows you to establish what the ten Custom
Command buttons will do.
1
Type a label for the button in Button 1 Text .
2
In ASCII Command(s) , enter a binary protocol such as hex commands. An
example is shown above.
3
Click Test button 1 commands to send the commands immediately. You will see
an output page showing the commands sent and replies received (if any). Use the
browser’s
Back button to return from this results page to avoid losing unsaved
changes. If you select the Custom Commands Setup page again, you will lose
unsaved changes.
4
Scroll to the bottom of the Custom Commands Setup page and click Change
Custom Command Buttons . This applies what you have done to the custom
buttons accessed from Custom Commands Setup at the top of the left menu.
Note: It is suggested that you only send one command at a time. If you want to send
additional commands, repeat the steps in this section.