19
Remote control
About the remote control signal
The remote control works with the
projector’s remote sensor. This projector
has two remote sensors on the front and
back sides.
The sensors can sense signals within
the following range:
60 degrees (30 degrees to the left and right of the
sensor) within 3 meters about.
• You can deactivate one of the sensors using the REMOTE RECEIV.
item in the SERVICE menu of the OPTION menu (
75
).
• The remote control signal re
fl
ected in the screen or the like may be available.
If it is dif
fi
cult to send the signal to the sensor directly, attempt to make the
signal re
fl
ect.
• The remote control uses infrared light to send signals to the projector (Class 1
LED), so be sure to use the remote control in an area free from obstacles that
could block the remote control’s signal to the projector.
• The remote control may not work correctly if strong light (such as direct
sun light) or light from an extremely close range (such as from an inverter
fl
uorescent lamp) shines on the remote sensor of the projector. Adjust the
position of projector avoiding those lights.
NOTE
Changing the frequency of remote control signal
The accessory remote control has the two choices on signal frequency Mode
1:NORMAL and Mode 2:HIGH. If the remote control does not function properly,
attempt to change the signal frequency.
In order to set the Mode, please keep pressing the combination of two buttons
listed below simultaneously for about 3 seconds.
(1) S et to Mode 1:NORMAL
AV MUTE
and
ZOOM -
buttons
(2) S et to Mode 2:HIGH
F5
and
KEYSTONE
buttons
Please remember that the REMOTE
FREQ. in the SERVICE item of the OPTION menu (
75
)
of the projector to be
controlled should be set to the same mode as the remote control.
(1)
ZOOM -
button
AV MUTE
button
(2)
KEYSTONE
button
F5
button
30°
3m
30°
30°30°
3m
(approx.)
