7
Panel Description
Encoder
Front Panel
No
Name
Description
1
Power LED
On: PF-IPEJ100F is powered on.
Off: PF-IPEJ100F is powered off.
2
Status LED
Solid on: PF-IPEJ100F is connected to both an
active video source and PF-IPDJ100F.
Blinking: PF-IPEJ100F is disconnected from an
active video source. / PF-IPEJ100F is disconnected
from PF-IPDJ100F.
Off: PF-IPEJ100F is powered off or in the boot
process. / Network is down.
3
Mode
Use this switch to toggle between normal and debug
modes
.
Normal (Default): In this mode, you can connect the
rear panel RS232 port to a RS232 device such as a
computer for bi-directional serial communication
with a RS232 device on the IP control box side.
Debug: In this mode, you can connect the rear
panel RS232 port to a RS232 device such as a
computer for debugging PF-IPEJ100.
4
DIP
This DIP switch consists of four manual switches, which
are used to route audio, video together with IR, and
USB signals between PF-IPEJ100F and PF-IPDJ100F
based on their positions. By default, each individual
switch is in the up position. For more information, see
"Using DIP Switch to Perform Routing".
Note:
For the DIP switches in both encoder and decoder,
changes to them take effect immediately without
rebooting the system.
