997-340-001, Issue 8
April 1998
ID1000 Series Operating Manual
6.1.8
Panel ‘ENGINEER’ Status
This is functionally identical to the NORMAL status except that it serves to indicate that a Passcode
has been entered by an authorised engineer in order to program the system. See the ID1000 Series
Programming Manual (997-340-003) for further details.
This condition remains active until cancelled by pressing the CANCEL pushbutton (note: not the
RESET), or the occurrence of any alarm, fault, etc. or until a two-minute period has elapsed with no
pushbutton having been pressed in the meantime. The indications of the panel and external equipment
are as follows:
LCD:
Status:ENGINEER
(date)
(time)
(blank)
or:
(system-normal message)
All other indications and external equipment:
as for status NORMAL
6.1.9
Panel ‘ENGINEER-MUTE’ Status
This is functionally identical to the NORMAL status except that a special option has been selected by
the authorised engineer to partially inhibit the functioning of the fault buzzer. Operation of the FIRE
internal sounder is not affected. This mode is normally used only during initial commissioning and
testing of a system. See the ID1000 Series Programming Manual (997-340-003) for further details.
The indications of the panel and external equipment are as follows:
LCD:
Status:ENG.-MUTE
(date)
(time)
(blank)
or:
(system-normal message)
All other indications and external equipment:
as for status NORMAL
6.1.10 Panel ‘PRINTER Control’ Status
The panel pushbutton ‘2’ (log/display) offers a choice of three printer control modes when a P40 or
PRN1000 printer has been configured (see Section 4.9.17 RS232 Mode Selection of the Programming
Manual). LCD messages are displayed only when the printer mode is other than ‘Normal’. The two
displayed printer modes are as follows:
LCD:
Status: NORMAL
(date)
(time)
PRINTER ON ‘HOLD’
or
LCD:
Status: NORMAL
(date)
(time)
PRINTER DISABLED
28
