11
Mono Mode Sequencing
Mono Mode Sequencing
The Touch Controller can quickly create sequences using the Channel Animator section. A Mono
sequence utilizes the Left, Right, and All Output Jacks. The ALL OUTPUT SECTION is updated with
every active step. If the active step is in the Left Zone, the LEFT OUTPUT SECTION is updated, if the
active step is in the Right Zone, the RIGHT OUTPUT SECTION is updated.
Clocking a Sequence
The sequence is clocked using the STEP INPUT JACK (10). Sending a trigger or gate into the STEP
INPUT JACK (10) will advance the sequence 1 step.
Mono Sequence Clock Divider
A clock divider can be used to divide the incoming clock signal. The clock divider can be set to ÷1, ÷2,
÷3, ÷4, ÷5, ÷6, ÷7, ÷8, ÷9, or ÷10. Set the clock division by pressing and holding the RESET/REST
BUTTON then pressing the corresponding TOUCH PLATE.
The selected clock division is not saved when the Touch Controller is powered off. The default clock
division is ÷1.
Resetting a Sequence
The sequence can be reset to step 1 a few different ways. Pressing the RESET/REST BUTTON (6)
resets the sequence to step 1. Sending a trigger or gate signal into the RESET INPUT JACK (9) also
resets the sequence to step 1.
