Pitney Bowes DI380 OfficeRight, Руководство оператора

Страница: 45 / 100

OMR • 3
3-7 SV61656 Rev.A
Retiming Mark
This mark is mandatory in each group of OMR marks making up
the code (see later in this section for an explanation of OMR mark
grouping).
It allows the machine to recalibrate for accurate scanning. Retiming
marks count in the parity calculation.
Select Feed (SF1, SF2)
These marks are used to control the feed of material from the feeder
holding the supplementary sheets/inserts on a set-by-set basis.
Therefore you cannot use select feed on a single station machine.
Select Feed 1 marks are used in the primary sheet feeder to select
material from the supplementary sheet feeder. For C- and double
folds, the primary feeder is sheet feeder 1. For Z- and single folds,
the primary feeder is sheet feeder 2.
Select Feed 2 marks are used in the primary sheet feeder to select
material from the Insert feeder. For C- and double folds, the primary
feeder is sheet feeder 1. For Z- and single folds, the primary feeder
is sheet feeder 2.
Auto Batch
This mark identifies the last set of a batch, when the batch function
is in use. It must be printed on all sheets of the OMR set that re -
quests this function.
Wrap Around Sequence (WAS1, WAS2, WAS3)
This is a numbering system which uses sequential binary coding. If
a page is missing or the set goes out of sequential order, the system
will stop processing and declare an error.
Three wrap around sequence marks are used within the code. The
use of three binary digits allows a decimal count of 0 to 7. Pages
will be numbered from 0 up to 7 and then back to 0 on a continuous
cycle throughout the print run.