ENGLISH
5
ASSEMBLY INSTRUCTIONS
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.
1. CONNECTING THE WHEEL TO THE SUPPORT LEG
Parts Required:
1 x Support Leg / Front
(#17-1)
1 x Support Leg / Back
(#17-2)
2 x Wheel
(#16)
2 x Wheel Cotter Pin
(#E)
2 x Wheel Washer
(#F)
2 x Wheel Axle Pin
(#G)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit and parts
during assembly. Attach the large Wheel to the Support Leg by inserting the
Wheel Axle Pin through the Wheel, Support Leg hole, then secure using the
Wheel Cotter Pin. Repeat installation for the other Wheel on same side.
ASSEMBLY PREPARATION
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss
®
Customer Service for parts: Monday
through Sunday, 4am - 8pm PST (EN/FR/ES).
[email protected] | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly:
screwdriver and level.
Tools not included.
1
G
16
17-1
17-2
16
G
F
F
E
E
