Flow Sensor
>
>
>
http://www.pisco.co.jp
Please be sure to read before handling the product. Please refer to "safety instructions", "common safety instructions for products listed in this manual", "common safety instructions for flow controller" from page 24 through 35.
25
Common Safety Instructions for Products Listed in This Manual
Danger :
1. Do not use PISCO devices with the following equipment:
(1) Equipment used for the sustenance or control of people's health or lives
(2) Equipment used for the movement or transport of people
(3) Equipment used specifically to ensure safety
Warnings :
1. Avoid the following uses for PISCO devices:
(1) Use under conditions not specified for the device.
(2) Use at outdoors, or at a place getting the direct sunlight.
(3) Use in locations where the device is exposed to excessive vibration or shocks.
(4) Use in locations where the device is exposed to any corrosive gas, inflammable gas, chemicals, seawater, or vapor.
* Certain PISCO devices, however, can be used in environments as described above. Therefore check on the specifications
for the use of individual devices.
2. Do not disassemble or remodel the PISCO devices in such a way as may affect the basic structure, performance or function of
them.
3. The maintenance check of product should be performed after turning the power off, stopping air supply, and confirming that the
pressure inside the plumbing becomes zero.
4. Never touch the release ring of the Quick-Fitting Joint when there is pressure working on it. Touching may release the ring,
which in turn may cause the tube to fall out.
5. Avoid too frequent switching of air pressure. Otherwise the device body may heat up to cause burns on you.
6. Do not allow tension, twist or bending forces to act on the products. Undue forces may damage theproducts.
7. For applications in which the threaded side or the tube connection side is subject to swinging or rotation, use Rotary Joints,
High Rotary Joints or Multi-Circuit Rotary Blocks only. Swinging or rotation may damage the joint body.
8. Except for Die Temp. Control Fitting, Tube Fitting Stainless SUS316, SUS316 Compression Fitting, and All Brass Compression
Fitting, please do not use products with hot water or thermal oil over 60
º
C. There is danger to cause the damage of the main
body of product by heat and hydrolysis.
9. For applications in which the scattering of static electricity or charging must be prevented, use no other joints than EG (anti-
static) specification products. Static electricity may cause system malfunction or trouble.
10. Never use joint other than Spatter spec. products or all metal products where they are exposed to spatter. Otherwise spatter
can cause fire.
11. Carry out maintenance and checks of equipment only after turning power off, shutting fluid off and making certain that the
pressure in the piping has dropped to zero. Please conduct maintenance after confirming following points.
(1) Make sure that maintenance is safe for all systems involving PISCO products.
(2) When re-activate equipment after maintenance, make sure safety measures against fly-out are taken and re-activate
equipment with care.
(3) Please secure space for maintenance when the circuit is designed.
12. When the fluid is admitted to the equipment and if there is a possibility to cause damage to it due to leakage, conduct safety
measures such as protective cover beforehand.
PISCO products are designed and manufactured for use with general industrial machinery and equipment. Therefore be sure to
observe the following safety instructions: