9
INSTALLATION OF THE POOL LINER (L)
Important: Install the liner with two or more people. The PVC used for our liners
has been designed to be exposed to the sun and UV rays for a long period of
time. Depending on the use given or the weather conditions, the characteristics of
this material may vary slightly.
Never walk on the liner with shoes or leave your tools or components on the liner.
Any puncture produced during assembly voids the warranty of the liner. SEE
WARRANTY OF THE LINER.
The liner is the most important and delicate part of the swimming pool. Do not use
knives or sharp objects to open the swimming pool package. Carefully separate
the liner from the rest of the components and keep it in a safe place to avoid
undesired punctures, tears or any other damage that could be caused by tools or
the steel wall.
Install the liner on a sunny day with a minimum temperature of 20ºC so that it is
warm and can be easily unfolded during installation. It is made of a highly flexible
vinyl material.
a) Place the liner (L) at the centre of the swimming pool and unfold it towards
the edge. Place the rough side on the outside. The welded part that joins the base
of the liner with the edge must match perfectly the lower sections and the wall
around the inside perimeter at the bottom of the swimming pool, fig.23.
b) Locate the side welding (SL) so that it is perfectly straight and perpendicular
to the ground. This will help you to place the liner without creases. Pull all the
excess of the liner delicately, do not pull too hard. The liner must be centred, well
extended and without wrinkles, fig 24.
c) Lift the side of the liner that covers the upper edges of the swimming pool and
fasten it to the top of the wall with pegs. Remove the creases by pulling smoothly
outwards and adjust the liner. Flatten the pool liner with your hands. Start filling
the pool with water, but only up to 2 cm. Make sure that the pool wall is straight. If
the level is off by more than 20 mm. across the diameter of the pool, empty the
pool, take the wall apart and level the foundation again.
Add 25 cm of water and smooth out all the creases and tighten the liner to the
wall. Fasten the liner with the plastic copings (PL) and remove the pegs at the
same time. Let the liner hang slack for now. Remove the plastic copings around
the top edge of the wall one piece at a time and adjust the liner.
When all the PL copings have been installed, mark with felt pen the overlapping
part, fig. 25, remove the copings and trim the extra length so there is no overlap.
Install the last plastic coping again. Then install the white profiles (PBS) on the
plastic copings (PL), fig. 26.
Important:
If your pool includes the decorated band, place it as instructed in the
manual, before installing the upper profiles (PBS).
IMPORTANT: CHECK
that the water is evenly distributed. If there are any
puddles, this means that the ground has a depression. If the water accumulates
on one side, this means that the area is uneven. In that case, the pool must be
emptied and dismantled completely and the installation must begin again so that
the ground can be levelled.
fig.23
fig.24
fig.25
fig.26
INSTALLING THE VERTICAL PROFILES (VER)
a. Line the bottom of one of the vertical profiles (VER) (1) with the two small tabs on the motherboard plate T1 (2).
The tabs must be inside the vertical profile, fig. 27.
b. Align the holes for the screws TO2 (3), (550 ref -. Mod 230th / 350th / 460th - Ref. 551 -. Mod 550th - Ref. 552 -
Mod 640th), on both sides of the vertical profile, making sure to fix the holes inside the tabs of the T1 plate (2), fig.
