Page
10
of
33
Figure 04-001: White silicone application and M14 nuts, hexagon socket bolts and
conical washers installation.
f.
Apply to M10 bolts to the holes drilled earlier and apply some Loctite 243 to the nut
thread. Then remove the two M8 bolts from before. Ream the two 8 mm holes with
the 10 mm drill bit, fit the last two M10 bolts and once again apply some Loctite 243
to the nut thread. Torque to 45 Nm
(See 32-10 in [8] and Figure 04-001).
Figure 04-002: Identification of drill geometry and proper undercarriage strut
orientation.
g.
Run the brake hoses from the undercarriage strut through the holes in the fuselage.
h.
Prepare the bottom cover plate by placing it in place and determine the right length.
Cut the cover plate with the scissor (Figure 04-003 step 1).
i.
Apply primer on the cover plate outer edge, let it dry and apply the double-sided self-
adhesive tape (Figure 04-003 step 2).
j.
Install the cover plate into previously determined position. Mind the alignment (Figure
04-003 step 3).
k.
Tape the edges with white self-adhesive tape. Carefully cut the redundant tape on the
corners (04-004 step 4).
