VSX-74TXVi
279
5
6
7
8
5
6
7
8
C
D
F
A
B
E
been muted (adjusting the volume also restores
boxes (for example,
INPUT SELECT
), or
reception of FM broadcasts. If the signal is
following controls can be accessed when listening
TV
- Use to turn on/off the power of the TV.
TV VOL +/–
- Use to adjust the volume on
your TV.
INPUT SELECT
- Use to select the TV input
signal.
TV CH +/–
- Use to select channels.
8 Component control buttons
The main buttons (
,
, etc.) are used to control
a component after you have selected it using the
input source buttons.
The controls above these buttons can be accessed
after you have selected the corresponding input
source button (for example
DVD/LD
,
DVR/VCR
or
TV/SAT
(when connected to a DTV)). The
to the built-in tuner:
MPX
- Switches between stereo and mono
weak then switching to mono will improve the
sound quality.
DISP
- Switches between named station
presets and radio frequencies.
9 STATUS
Press to check selected receiver settings.
10 MULTIOPE
Use this button to perform multi operations.
11 SHIFT
Press to access the controls outlined in white
to display the currently selected input source in
the remote control LCD.
12 SOURCE
Press to turn on/off other components connected
to the receiver.
13 Character display (LCD)
This display shows information when transmitting
control signals.
The following commands are shown when you're
setting the remote to control other components
(see Controlling the rest of your system):
SETUP
- Indicates the setup mode, from which
you choose the options below.
PRESET
- See Selecting preset codes directly.
LEARNING
- See Programming signals from
other remote controls.
MULTI OP
- See Multi Operation and System
Off.
SYS OFF
- See Multi Operation and System
Off.
DIRECT F
- See Direct function.
RENAME
- See Renaming input source names.
ERASE
- See Erasing one of the remote control
button settings.
RESET
- See Resetting the remote control
presets.
READ ID
- See Confirming preset codes.
14 RECEIVER
Switches the remote to control the receiver (used
to select the green commands above the number
buttons (
ANALOG ATT
, etc). Also use this button
to set up surround sound. With SHIFT, this selects
selects the multi-room control, shown in the display
as
RCV/RM2
,
RCV/RM3
.
15 VOL +/–
Use to set the listening volume.
16 MUTE
Mutes the sound or restores the sound if it has
the sound).
17 Receiver controls
SIGNAL SEL
- Use to select an input signal.
SBch
- Use to select the surround/virtual back
channel mode.
STEREO
- Switches between direct and stereo
playback. Direct playback bypasses the tone
controls and any other signal processing for
the most accurate reproduction of a source.
THX
- Press to select a Home THX listening
mode.
STANDARD
- Press for Standard decoding
and to switch between the various Pro Logic
IIx and Neo:6 options.
ADV.SURR
- Use to switch between the various
surround modes.
18 PHASE
- Press to switch on/off phase correction.
MCACC
- Press to switch between MCACC
presets .
S.DIRECT
- Press to select Auto Surround
or Stream Direct listening.