Adjusting the brightness
You can adjust the display brightness. Initially
this mode is set to 12.
1 Use Multi-Control to select Brightness.
Brightness
appears in the display.
2 Push Multi-Control left or right to ad-
just the brightness level.
Each pushing
Multi-Control
left or right in-
creases or decreases the brightness level.
0
15
is displayed as the level is increased or
decreased.
Setting the rear output and
subwoofer controller
This unit
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Rear SP :FULL
) or subwoofer
(
Rear SP :S/W
) connection. If you switch the
rear output setting to the
Rear SP :S/W
, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
Rear SP :FULL
). When rear out-
put is connected to full range speakers (when
Rear SP :FULL
is selected), you can connect
the RCA subwoofer output to a subwoofer. In
this case, you can select whether to use the
subwoofer controller
s (low pass filter, phase)
built-in
Preout :S/W
or the auxiliary
Preout :FULL
.
1 Use Multi-Control to select SW control.
SW control
appears in the display.
2 Press Multi-Control to switch the rear
output setting.
Pressing
Multi-Control
will switch between
Rear SP :FULL
(full-range speaker) and
Rear SP :S/W
(subwoofer) and that status will
be displayed.
#
When no subwoofer is connected to the rear
output, select
Rear SP :FULL
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
Rear SP :S/W
.
#
When the rear output setting is
Rear SP :S/W
,
you cannot change the subwoofer controller.
3 Push Multi-Control left or right to
switch the subwoofer output or nonfading
output (full-range RCA output).
Each pushing
Multi-Control
left or right will
switch between
Preout :S/W
and
Preout :FULL
and that status will be displayed.
Notes
!
Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to
Using nonfading output
on page 46)
or subwoofer output (refer to
Using subwoofer
output
on page 45) in the audio menu on.
!
If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
!
Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
!
The sound is turned off or attenuated,
MUTE
or
ATT
is displayed and no audio ad-
justment is possible.
!
Sound from this system returns to normal
when the muting or attenuation is can-
celled.
Initial Settings
En
50
Section
11