4
En
• Pioneer is not responsible for any accidents or damage that
result from improper installation, misuse or modification of
the product, or natural disasters.
Applying non skid pads
The use of non skid pads is recommended depending on the
installation location. Apply the pads to the four corners of the side
of the speaker which will be on the bottom. Note that depending
on the location, the pads may not provide fully sufficient traction
to prevent slipping, so care should be taken not to install the
speakers in conditions where they may be prone to side.
• When applying non skid pads, laid down the speaker on the
soft cloth etc. to avoid working with unstable position.
Attaching and removing the grille
The front grille net can be removed if desired. To remove, follow
these instructions:
1
To remove the grille, place your hands at the bottom of
the grille and pull gently outward. Then do the same at the
top to detach.
2
To reattach the grille, align the four holes on the grille’s
back with the pins on the speaker and press in firmly.
Connections
1
Switch off the power of your amplifier.
2
Connect the speaker cables to the input terminals on the
back of the speaker. For input terminal polarity, red is
positive (+) and black is negative (–).
Loosen the knobs on the input terminals and insert the speaker
cable wires into each of the terminal post holes, then tighten the
knobs.
3
Connect the other ends of the cables to the amplifier’s
speaker output terminals (for details, refer to your
amplifier’s instruction manual).
• You can also connect the speaker’s terminals with a banana
plug.
• When using a banana plug, first remove the caps covering the
speaker terminal.
• After connecting the plugs, pull lightly on the cables to make
sure that the ends of the cables are securely connected to the
terminals. Poor connections can create noise and
interruptions in the sound.
• If the cables’ wires happen to be pushed out of the terminals,
allowing the wires to come into contact with each other, it
places an excessive additional load on the amplifier. This may
cause the amplifier to stop functioning, and may even damage
the amplifier.
• When using a set of speakers connected to an amplifier, you
won’t be able to obtain the normal stereo effect if the polarity
(+, –) of one of the speakers (left or right) is reversed.
Non skid pad
Speaker cable with white
line
Connect to the stereo
amplifier's positive (+)
output terminal.
Speaker cable without line
Connect to the stereo amplifier's negative (
–
) output terminal.
CAUTION
These speaker terminals carry HAZARDOUS LIVE
voltage. To prevent the risk of electric shock when
connecting or disconnecting the speaker cables,
disconnect the power cord before touching any
uninsulated parts.
D3-4-2-2-3_A1_En
S-CN301-LR.book 4 ページ ２０１２年２月１０日 金曜日 午後４時３７分
