FRONT
(front speakers)
CENT
(center speak-
er)
REAR
(rear speakers)
SUB.W
(subwoo-
fer)
PHASE
(subwoofer setting)
#
You can switch to
PHASE
only when the sub-
woofer has been set to
ON
.
3 Press
r
or
q
to select the correct size
for the selected speaker.
Each press of
r
or
q
selects the size in the
following order:
SML
(small)
LRG
(large)
OFF
(off)
#
You cannot select
OFF
, when
FRONT
(front
speakers) have been selected.
#
You can select
ON
or
OFF
, when
SUB.W
(sub-
woofer) has been selected.
#
You can switch
REV
(reverse phase) or
NOR
(normal phase), when
PHASE
(subwoofer setting)
has been selected.
4 Press BAND to return to the playback
display.
Correcting the subwoofer
s phase
If trying to boost the bass output of the sub-
woofer doesn
t do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer
s output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Press A and hold until FRONT appears
in the display.
2 Press
m
or
n
to select the subwoo-
fer.
Each press of
m
or
n
selects the speaker
in the following order:
FRONT
(front speakers)
CENT
(center speak-
er)
REAR
(rear speakers)
SUB.W
(subwoo-
fer)
PHASE
(subwoofer setting)
3 Press
r
to turn the subwoofer output
on.
4 Press
n
to select PHASE (subwoofer
setting).
5 Press
q
or
r
to select the subwoofer
output phase.
Press
r
to select
NOR
(normal phase). Press
q
to select
REV
(reverse phase).
6 Press BAND to return to the playback
display.
Note
When playing a 2-channel mono source with Pro
Logic
B
turned on, there may be occasions when
the following will occur:
!
No audio is outputted if the center speaker
setting is
SML
or
LRG
and no center speaker
is installed.
!
Audio is heard only over the center speaker if
installed and the center speaker setting is
SML
or
LRG
.
Selecting a cross-over
frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to
SML
, you can select a fre-
quency, under which sounds are reproduced
through a
LRG
speaker or subwoofer.
1 Press A and hold until FRONT appears
in the display, then press A to select HPF.
After
FRONT
is displayed, press
A
until
HPF
appears in the display.
Digital Signal Processor
En
68
Section
12
