Messages and how to react to them
The following messages may be displayed by your navigation system. Refer to the table below to
identify the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Messages for navigation functions
Message
When
What to do (Reference)
Route calculation was not
possible.
Route calculation has failed be-
cause of a malfunction in map data,
software, or hardware.
!
Change the destination.
!
Consult the Pioneer Local dealer if this mes-
sage persists.
Route calculation not possi-
ble: destination is too far.
The destination is too far.
Set a destination closer to the starting point.
Route calculation not possi-
ble: destination is too close.
The destination is too close.
Set a destination farther from the starting
point.
Route calculation not possi-
ble: navigation cannot be pro-
vided around destination or
starting point.
The destination, waypoint(s), or
starting point are in an area where
no road exists (e.g. a mountain) and
the route calculation is impossible.
!
Set a destination and waypoint(s) on roads.
!
Reset the destination after you drive the ve-
hicle to any road.
Route to destination cannot
be calculated.
The destination or waypoint(s) are in
an isolated island, etc. without a
ferry and the route calculation is im-
possible. If there is no road con-
nected to your starting point or
destination, this message will ap-
pear.
Change the destination.
Failed to make the route pro-
file.
In rare cases, a route calculation
error may occur.
!
Retry.
!
Consult the Pioneer Local dealer if this mes-
sage persists.
Application startup failed.
Check file on SD card. Press
“
OK
”
to exit Application
Mode.
The application is not stored on the
SD memory card.
Use the utility programme navgate FEEDS to
confirm the proper solution.
The application failed to download
properly.
Use the utility programme navgate FEEDS to
confirm the proper solution.
A file required for application start-
up is not stored on the SD memory
card or is damaged.
Use the utility programme navgate FEEDS to
confirm the proper solution.
The SD memory card is damaged.
Make sure there are no problems with the SD
memory card.
Engb
64
Appendix
Appendix
Содержание AVIC-F220
Страница 74: ...Engb 74 ...
Страница 75: ...Engb 75 ...