Pinnacle microguard, Руководство по установке

Страница: 18 / 48

Resetting the MicroGuard
Error messages are stored in a nonvolatile memory
(EEPROM). To clear error messages, press the RESET
button. DO NOT hold in the button or hit it twice,
just one hit. The unit will not reset until it is finished
displaying the entire error message.
If you remove power from the unit without clearing the
error message, the message will reappear when you
power back up. Hit the RESET button to clear this error
from memory.
The RESET button is located inside the MicroGuard
Controller Module on the door circuit board, left hand
side, or the lower circuit board underneath the gray
ribbon cable to start up the light curtain.
You can review all previous error messages recorded
by holding down the RESET button while turning on the
power to the unit, for two seconds. Each error message
will scroll by, last error first. When you see the message
“NO MORE CODES,” hit the RESET button to start up
the curtain. Up to 45 previous error messages can be
displayed. You can shut down the curtain during normal
operation by pressing the RESET button.
Installation Procedures
Metal Box Controller Module
8