Pinnacle Technology PP7X Series, Руководство по эксплуатации

Страница: 62 / 76

59
∗
If the horizontal direction length or vertical direction length is 0, the command is stopped and normal printing
commences from subsequent data.
∗
The character expansion starting point is the point specified by selecting the character printing direction (ESC
T) in page mode in the print region.
∗
If (horizontal direction starting po horizontal direction length) exceeds the printable region in the
horizontal direction, the horizontal direction length is set to (horizontal direction printable region - horizontal
direction starting point).
∗
If (vertical direction starting po vertical direction length) exceeds the printable region in the vertical
direction, the vertical direction length is set to (vertical direction printable region – vertical direction starting
point).
∗
The basic calculated pitch is set by GSP (Set basic calculated pitch). Also, the set printing region is not
changed even if the basic calculated pitch is changed after setting the print region.
∗
If the calculation results in fractions, the pitch is corrected to a minimal mechanical pitch and the rest is
discarded.
∗
The basic calculated pitch (x) is used in the calculated pitch for the horizontal direction starting point and the
length in the horizontal direction; and the basic calculated pitch (y) is used in the calculated pitch for the
vertical direction starting point and the length in the vertical direction.
∗
The print region shown in the figure below when the horizontal direction starting is X; the vertical direction
starting point is Y; the horizontal direction length is Dx; and the vertical direction length is Dy.
Reference:
CAN, ESC L, ESC T, GSP
z
ESC @
Initialize printer
Format: ASC
Ⅱ
ESC @
Decimal 27 64
Hex 1B 40
ESC @ initializes the printer. All settings, including character font and line spacing settings, are canceled.
The data in the print buffer is cleared and the printer mode is reset to the mode that was in effect when the
power was turned on. The DIP switch settings are not checked again, the data in the receive buffer is not cleared,
and any macro definitions are not cleared.