Pilous ARG 260 CF-NC automat, Инструкция по эксплуатации

Страница: 27 / 27

OPERATIONAL POP-UP WINDOWS
Operational pop-up windows have a grey color and
appear in the middle of the work screen. They appeal
to the user for deciding on the continuation of the
process. After taking the decision, the window will
disappear.
If the material is used up, the operator is informed via
this window. After pressing the OK button, the fixed
vice is released. The system switches to the default
screen of the NC mode. Now there is the option to
switch the machine to manual mode and cut the rest
of the material manually, or insert new material and
start the cycle. Cycle will resume where it ended.
Before continuing the cycle, you can choose
downcutting and align new material.
FAILURE POP-UP WINDOWS
Failure pop-up windows have a black color and appear in the middle of the work screen.
They inform the user about malfunction. The failure is immediately recorded in the error
status on the Failures screen. Execute the cancellation of the pop-up window after solving
the failure, by clicking in the area of the pop-up window.
Under the main announcement, status of sensors for easy detection of failures may
appear:
BP - Limit switch
TS - Pressure switch
Blue square signalizes that the device is switched on.
More about failure reporting in chapter Failures.
PERFORM
KERF?
NO YES
INFORMATIONAL POP-UP WINDOWS
Informational pop-up windows have a blue color and appear in the middle of the work
screen. They inform the users about the status changes or about non-failure conditions.
List of information windows:
The number of series is greater than 10
- indicates that the number of active series
exceeded the amount that can be displayed on the screens of the Main menu, NC mode,
Performing series and Series interrupted.
Insert the material - informs you that the material has not been inserted.
Material will be shortly used up. Prepare new - informs that the material will soon have
been cut. In order to continue the series, it is necessary to prepare new material.
Performing downcutting - informs that the machine performs downcutting of the ends of
the inserted material. Replace battery in the PLC. Charge is less than 50% - indicates
that the backup battery is at the end of service life and should be replaced with a new one.
Designation of the battery by Schneider Electric: TSXPLP 01.
FAILURE TS
Pressure sensor
fixed vice
(right-R)
%IX0.3 BP7 %IX0.6 TS2
Replace the
battery in the
PLC.
Charge is less
than 50%.
Material ending.
Load new material
Press OK to open fixed vice
OK