Pilous ARG 260 CF-NC automat, Инструкция по эксплуатации

Страница: 18 / 27

The entire working cycle consists of:
• clamping of the fixed vice (also manually by pressing the Vice
button) • starting of the saw blade • switching on of the saw
blade arm descent into the cut - performing the cut • ascending
of the saw blade arm to the upper position • stopping of the saw
blade • fixed vice opening
AMMETER
0.0 A
Ammeter - measures the saw blade motor
load. The diode indicates overload of the
main motor.
65
15 90
BLADE SPEED
m/min
Saw blade speed 15-90 m/min
Start/Stop of a semi-automatic cycle
mm
0.0
123.5
The editing fields are displayed in light gray with red
bordering. After you enter the value (ranging from 0 to 500
mm, including the kerf and the correction) and pressing the
red Vice icons, the movable vice starts moving to the desired
position, the green diode is flashing and the lower black
display shows the current position of the vice. After the
transfer is complete, the green diode remains on
permanently.
You cannot move the vice when both vices are clamped! If
you initiate any function that is logically preceded by a
different function (that has not been activated yet), the button
of the preceding function will start flashing to indicate error.
Moving of the movable vice
L R
Vice
closed
Vice
open
If the vice is open, press the START button of the
WORKING CYCLE in the SEMI-AUTOMATIC MODE
to perform the cycle. After finishing, the vice remains
open.
If the vice is closed, press the START button of the
WORKING CYCLE in the SEMI-AUTOMATIC MODE
to perform the cycle. After finishing, the vice remains
closed.
For example, when switching from the AUTOMATIC
MODE to the SEMI-AUTOMATIC MODE, the machine
does not automatically switch to the starting position.
Therefore is it necessary, after checking the position of the
material etc., to press the PRIMARY POSITION button -
the hydraulic unit will switch on, the arm will ascend to the
upper (adjustable) position, the vices will release and the
left vice will move to position 0 mm (inactive in this mode).
When switching to the primary position, the PRIMARY
POSITION button is flashing. After switching, the green
diode lights up.
PRIMARY
POSITION
mm/min
0
CORRECTION
0.00
HEIGHT
340
mm
mm
0
Correction of the material feed length
Setting Band Saw Arm Ascent Height
The editing field is displayed in light gray with red
bordering. After you enter the value and press the ENTER
key, the arm will ascend to the upper position and the lower
black box will show the current position of the arm.
Speed of the arm descent to the cut
4.1.3. Semi-automatic mode
SEMI-AUTOMATIC MODE
S.A. MODE
0 9 : 2 0 : 0 3 0 8 / 1 0 / 2 0 1 6
CORRECTION
L R
65
15 90
BLADE SPEED
m/min
AMMETER
0.0 A
mm
0.0
123.5
0.00
HEIGHT
340
mm
mm
mm/min
0
0
PRIMARY
POSITION