1. Transport and storage
DANGER OF DAMAGE!
1.4. Dismantling
Empty and clean the metal chips tank and the coolant tank. Clean the machine. Provide the sliding surfaces with antirust oil. Make
sure that the machine has been disconnected from electrical energy supply. Prepare the swing arm protection for transport. Lift the
machine and screw on the wooden frame. Provide a clearance of approx. 100 mm for transport by a fork lift truck. Check whether all
protective covers of the machine are screwed on. Enclose the machine accessories.
Endangering with dangerous matters cannot be excluded when handling coolants. Observe in your
own interest the manufacturer's and/or your company's instructions and recommendations/operating
instructions related to safe handling with coolants.
Standard accessories:
1 bimetallic saw band M 42 (mounted)
1 coolant unit with a metal chips tank
1 length stop 500 mm
1.1. Surface Treatment
1.2. Packing
1.3. Installation
The machine is provided with a primer and a two-component polyethane varnish. The sliding surfaces are provided with antirust oil.
The other machine parts are zinc coated or blackened.
The basic element of the package is a wooden frame which according to the kind of dispatch may be crating or an overseas case.
Approximately 100 mm clearance should be provided for transport and loading by a fork lift truck. For the transport the machine is
packed in a stretching foil protecting against weather influences.
Remove the wooden frame. Position the machine at site. Align the machine by a water level and four M12 setting screws in the base
corners. Remove antirust protection and dust from the sliding surfaces and apply oil again. Attach the length stop. Make sure that
energy supply is connected (see chapter 4.3). Opening the base door, make sure that the coolant discharge pipe has not come off
the coolant tank cover and is correctly attached in the tank. Fill the machine tray with the coolant (approx. 15 litre), the fluid will
continuously pour into the tank in the base.
The machine maybe transported and lifted only by a fork lift. USING A CRANE IS NOT PERMITTED!
CAUTION : Used coolants are special waste!
Disconnecting the machine from the electrical energy supply may be only carried out
by electricians!
1.5. Disposal
When the machine has been definitely put out of operation, it should be disposed of in accordance with the provisions valid in the
respective country. We recommend to contact a company specialized in waste disposal.