The oil damper with a relief valve allow for a continuous adjustment of the speed of the band cutting feed or its stabilizing in any
position. It acts against the arm weight being regulated by mechanical turning the lever over the scale. The tension spring acts as the
required load balance.
5.6. Oil Damper - saw band feed into cut
SPEED UP
OF ARM FEED
SPEED DOWN
OF ARM FEED
STOP
OF ARM FEED
5.7. Cooling equipment
The basis of the cooling equipment is a pump and the coolant tray located in the machine base. The coolant tray can be taken out
separately. The coolant pump conveys the coolant through hoses, valves and guide heads to the band. The coolant quantity is
controlled by these valves. The coolant provides band cooling and lubrication and chip flushing. The pump switches on and off
simultaneously with the band drive start or shutdown.
Hazards due to dangerous matters cannot be excluded while handling coolants. Observe the manufacturer's
and/or your company's instructions and recommendations concerning handling of coolants.
On the coolant tank is overflow hole which secure the proper quantity of coolant fluid. This is to protect the
coolant pump from being overflow and damaged. In case of infusion of bigger volume the coolant fluid may
run under the band saw.
INPUT HOSE
TAP
SIEVE
COOLANT FLUID TANK
TRASH HOSE
SETTING POT
OVERFLOW HOLE
PUMP
