PIKA REbus Beacon, Руководство по установке

Страница: 9 / 12

9 REbus Beacon Installation Manual M00020-01
Section 4: Commissioning Beacon
Section 4: Commissioning Beacon
Note: If this is a new Energy Island installation, follow all commissioning procedures for the Islanding
Inverter and all connected REbus devices before continuing.
For complete information on powering on and commissioning the inverter, using the inverter front
control panel, and working safely with the Islanding Inverter, refer to the Islanding Inverter Installation
and Operation Manuals. For information on commissioning and configuring other REbus devices, refer
to individual device documentation.
Commissioning Beacon consists of three steps:
1. Power on the system and verify connections
2. Enable all REbus devices
3.
Configure Beacon
Step 1: Power on the system and verify connections
1. Power on the Islanding Inverter by turning on the AC breaker.
2. If prompted, follow the on screen directions to exit the Safety Shutdown.
3. Use the left and right arrow buttons to scroll through the device pages. Verify that
there is a Beacon device page.
4. Make sure the blue Internet LED on the front of the inverter is illuminated. If the LED is
not illuminated, navigate to the inverter Ethernet Settings page and Disable ethernet.
Step 2: Enable all REbus devices
1. Turn on the DC breakers for each connected device.
2. Enable the inverter, wait a few seconds for it to connect to the other devices, then
enable each device.
3. Turn the front “Battery Disconnect” switch ON for each smart battery.
Note: Refer to the Islanding Inverter Operation Manual for more information on enabling devices.
4. Navigate to the Ethernet Settings page on the inverter control panel and disable
Ethernet. Refer to the Islanding Inverter Installation Manual for more information on
enabling and disabling ethernet.