PIKA REbus Beacon, Руководство по установке

Страница: 7 / 12

7 REbus Beacon Installation Manual M00020-01
Section 3: Installing Beacon
Install the ethernet and power cable assembly
1. Connect the power leads to the black 16-pin accessory terminal block.
i. Connect the red wire (labeled “5V”) to the “5V” terminal on the accessory
terminal block.
ii. Connect the black wire (labeled “GND”) to the “GND” terminal of the accessory
terminal block.
Fig 1. Connect the power leads to the GND and 5V terminals black 16-pin accessory terminal block.
2. Connect the female ethernet connector to the internet.
i. Locate the incoming ethernet cable that connects the inverter to the internet. It
is connected to the ethernet port located behind the DC wiring terminals. Unplug
the incoming ethernet cable from this location.
ii. Connect the incoming ethernet cable to the female ethernet connector at the end
of the Beacon ethernet and power cable assembly.
Install the new wiring compartment cover with Beacon at -
tached
1. Pass the ethernet and power cable assembly through the passthrough opening at the
top of the cover.
2. Attach the cover using the wiring compartment cover screws.