PIKA REbus Beacon, Руководство по установке

Страница: 10 / 12

10 REbus Beacon Installation Manual M00020-01
Instructions
Step 3: Configure Beacon
1. Return to the Beacon device page.
2.
Enter the Settings menu to access all settings, including the Time of Use (TOU)
schedule and time zone.
Note: Refer to the REbus Beacon Operation manual for complete instructions on navigating the menus
and adjusting settings.
3. Beacon will immediately enable and begin running the TOU schedule.
Section 5: Troubleshooting
Problem: There is no REbus Beacon device page on the inverter front control panel.
• Check that Beacon’s power cable is plugged in to Beacon, the power wires are secure
in their terminals inside the wiring compartment, and their polarity is correct. Check
for voltage at the power terminals; verify there is 5V between them.
• The 16-pin accessory terminal block is removable. Push gently on the terminal block
to make sure it is fully seated in its socket.
• Check that the USB cable is connected at both ends. Be certain that it is correctly
connected to the port inside the Power Core.
Problem: The Inverter isn’t connecting to the server.
• Make sure the Ethernet Settings page on the inverter control panel reads “Disabled”.
• Make sure all ethernet connections are secure. If using a field-built cable for your
connection, check that the cable is made correctly.
• If your system requires manual DHCP setup, contact Pika Energy for assistance.
Note: Pika Energy does not recommend or support connection to the internet using a wifi bridge or
router set up in “bridge” mode. The Islanding Inverter does not communicate reliably through this
type of device. Use these devices at your own discretion.
Technical Support Information
Support department hours: 9AM to 5PM Eastern Time, Monday – Friday (excluding holidays)
Phone: (207) 808-0362
Email: support@pika-energy.com