Picomed ER2AC, Документация

Страница: 5 / 11

ER2AC, ER4AC Page 5.
The main components on the PCB are two programming buttons ("1" knapp, "0" knapp), one
LED (Lysdiode) and a IR-sensor on the PCB.
The programming buttons are indicated as "0" and "1" (binary notation). The following
parameters can be programmed:
User code and channels.
Lockcode.
Working mode for the relays.
User code and channel can be set with the help of a preprogrammed IR-remote controller. The
working mode for the relays has to be set with the programming buttons. The receiver can be
reprogrammed any time, and there is no limit for how many times it can be reprogrammed.
2.3.1 How to program the IR-receiver
Enter programmaing mode by press & hold the "0" button for 5 seconds. Let off the
button when the LED is lightning.
The programming can be done by writing "programming-words"; PW, which consists of
sequences containing "0" and "1". The PW's should be written down before the
programming starts to avoid any trouble due to timeouts during the programming.
If a wrong input is made, press an hold the "0" button for 5 seconds to leave the PW and
go back to programming mode without saving data.
There will be a timeout after 60 seconds if no keys are pressed.
When entering of a PW is started a pause of more than 15 seconds between two bits will
result in timeout of a PW.
Only completed PW will be stored.
2.3.2 LED behaviour during programming mode
In programming mode the LED will be on.
When a PW is started, the LED will flashing rapidly.
When entering a bit, the LED will turn of for a moment.
When a PW is done and all bits accepted, the LED will flash slowly twice.
The IR-receiver will have the same behaviour when it is programmed by the help of an IR-
transmitter.
”1” knapp ”0” knapp Lysdiode IR-sensor