PI V-551.2D, Руководство пользователя

Страница: 25 / 71

5 Installation
V-551 Linear Stage MP160E Version: 1.1.1 21

You have accounted for the space required to route cables without bending and
according to regulations.
Tools and accessories

Mounting accessories:
−
For mounting from above: 4 M6x30 screws (in the scope of delivery (p. 9)) or
4 M4 screws of suitable length
−
For mounting from below: 4 M6 screws of suitable length

Suitable tools for tightening the screws
Mounting the V-551 on a surface
1. Align the stage on the surface so that the corresponding mounting holes in the stage
and the surface overlap.
2. Completely screw in the screws into all mounting holes.
For mounting from above:
− Move the motion platform to the factory-set end of the travel range each time to
make the mounting holes accessible.
Maximum permissible torque:
− M6: 8.8 Nm
− M4: 2.6 Nm
3. Check that the stage is affixed firmly to the surface.
5.4 Setting Up a Multi-Axis System
The V-551 can be used in XY systems.
Designations in these instructions:

Lower stage : Forms the basis of the multi-axis system (X axis); is mounted on a surface

Upper stage
: Forms the Y axis of the multi-axis system; is mounted on the lower stage
rotated by 90°
5.4.1 General Notes on Setting Up a Multi-Axis System
NOTICE
Impermissibly high load on the stages!
In an XY system, the stage for the Y-axis must be moved as well. Impermissibly high loads
interfere with the motion and can damage the stages.

Include the mass of the moved stage in the calculation of the load to be moved.

For all stages in a multi-axis system: Do not exceed the maximum permissible load.