PI M-230 Series, Руководство пользователя, Страница: 25 / 47

5 Installation
M-230 Linear Actuators MP102E Version: 1.2 21
Figure 7: Clamp connection (schematic)
1 Mechanical mounting
2 Sleeve
3 Mounting nut, 3/8 inch
4 Mounting shaft with thread
5 Pusher with tip (flat)
We recommend installing the actuator in the mechanical mounting with a clamp
connection. The following instructions refer to this case.
Prerequisites

You have read and understood the General Notes on Installation (p. 15).

You have provided your application with a suitable mounting for the mounting
shaft of the actuator.
Tools and accessories

Supplied hook wrench (p. 11)
Installing the actuator
1. Loosen the mounting nut on the mounting shaft of the actuator.
2. Position the actuator in the mounting of your application.
3. If necessary, stick a suitable flat washer or a suitable spring washer on the
mounting shaft.
4. Manually screw the mounting nut into the thread of the mounting shaft with a
few rotations.