Phytec phyCORE-P87C591, Быстрый старт

Страница: 35 / 84

Getting Started
© PHYTEC Meßtechnik GmbH 2002 L-586e_2
31
•
Selecting OK advances you to the COM Direct–HyperTerminal
monitoring window. Notice the connection status report in the
lower left corner of the window.
•
Resetting the phyCORE Development Board LD 5V (at S2) will
execute the Hello.hex file loaded into the Flash.
•
Now push the <Space> bar on your keyboard once to start the
automatic baud rate detection on phyCORE-P87C591 module.
•
Successful execution will send the character string "Hello World"
from the target hardware to the HyperTerminal window.
Pressing any other key than the <Space> bar leads to an improper
baud rate since the automatic baud rate detection is based on the
timing measurement during the transmission of a well known
character – the <Space> character. As a result you may get
incoherent characters in the HyperTerminal window.
•
Click the disconnect icon in HyperTerminal toolbar and exit
HyperTerminal.
•
If no output appears in the HyperTerminal window check the
power supply, the COM parameters and the RS-232 connection.
You have now successfully downloaded and executed two
pre-existing example programs in Intel *.hex file format.