Phytec phyCORE-ADuC812, Быстрый старт

Страница: 68 / 86

phyCORE-ADuC812 QuickStart Instructions
64
© PHYTEC Meßtechnik GmbH 2002 L-462e_2
4.5 Keil µVision2 Debug Features
•
The Debugger window toolbar gives access to the following
debug commands: Reset, Run, Stop, Step Into, Step Over, Step Out
and Run to Cursor line.
Reset
Run
Stop
Step Into
Step Over
Step Out
Run to Cursor line
•
The first button on the debugger toolbar is the Reset
button.
The Reset command sets the program counter to 0. However, it
should be noted that peripherals and SFRs of 8051 devices are not
set into reset state. Therefore this command is not identical to a
hardware reset of the CPU.
•
The button to the right of the Reset button starts the Run
command.
Clicking this button runs the program without active debug
functions. To stop program execution at a desired point, a
breakpoint can be placed before the Run button is pushed.
•
The next button on the debugger toolbar is the Stop button.
The Stop button interrupts and stops the running program at an
undetermined location.