PHOTONIS NOCTURN XL, Руководство пользователя

Страница: 23 / 39

Camera Serial Commands | NOCTURN XL Camera | 23
Name Address Size Description
INTE_SECOND 10-12 24
The number of slots light integrates on the pixels for the
2nd slope of the response curve.
By default, the second slope is not used, so the default
value is 0.
INTE_THIRD 13-15 24
The number of slots light integrates on the pixels for the
3rd slope of the response curve.
By default, the third slope is not used, so the default value
is 0.
ADC_CALIB_MODE 16 2 Set the ADC calibration mode:
0

No calibration
1

Calibration during overhead row
2

Calibration at start of each (conversion) row
(60 fps mode only!)
3

Calibration during overhead row and at start of each
(conversion) row (60 fps mode only!)
COL_CALIB_MODE 16 1 Set the column amplifier calibration mode:
0
 No calibration
1  Calibration at start of each row
CLOCK_SELECTION 17 2 Select the (input) high speed clock:
0

LVDS input clock
1

Analog PLL
2 & 3

Digital PLL
SELECT_PULSED 18 1 Change the behavior of the row select:
0  Select constant high during sampling
1

Select is low during transfer
CLK_ADC_CONT 18 1 Set the behavior of the ADC clock
0

ADC clock stops between reset and signal
conversion
1

ADC clock continues to toggle between reset and
signal conversion
COL_EB 18 1 Controls behavior of electrical black columns
0  All columns normal
1  First 20 columns (in non-flipped readout) are black,
rest are normal
DB_TEST_IMAGE 18 1 Disable/Enable digital test image output
DB_OVF_DISABLE 18 1 Change the handling of large conversion results
0

Output is clipped at ‘1111111111’
1

Output overflows and outputs lowest 10 bits
DB_LOAD_FALLING 18 1 Change the clock edge that is used to sample the
digital data when going from parallel to serial data
FLIP 19 2 0

Read out left bottom to right top
1

Read out right bottom to left top
2

Read out left top to right bottom
3  Read out right top to left bottom
OFFSET_60FPS 20-21 10 Offset in 60 fps mode.
OFFSET_100FPS 22-23 10 Offset in 100 fps mode.
TRAINING_WORD 24-25 10 Set the training word that is sent on the data
channels when the sensor is idle
PHOTONIS Digital Imaging LLC NVT 200-LC-4019
6170 Research Road Suite 208 Revision: C.04
Frisco, TX USA 75033 Page 23 of 39