PHOTONIS NOCTURN XL, Руководство пользователя

Страница: 21 / 39

Camera Serial Commands | NOCTURN XL Camera | 21
Echo Commands
By default the NOCTURN camera is shipped with the echo turned off on all serial interface port. The
echo command can be used to turned the echo on or off on any serial of the communication ports.
All valid serial command shown in Table 8 should be sent as:
echo <Port> <Optional Payload><CR><LF>
Table 8: Echo commands
Command Optional Payload Description
? Echo help menu
USB 0
1 USB port echo off
USB port echo on
AUX 0
1
AUX port echo off
AUX port echo on
DBG 0
1
Debug port echo off
Debug port echo on
CS Commands
CAUTION
Adjusting the default CMOS settings could affect the low light level
performance of the camera and the default non-uniformity correction
tables.
All valid serial command shown in Table 9 should be sent as:
CS <Command> <Optional Payload><CR><LF>
Table 9: CS Commands
Command Optional Payload Description
?
CS command help menu
cs blank_enable 0
1
Disables blank screen on sensor loss of lock
Enables blank screen on sensor loss of lock
cs lnf 0
2
4
8
16
Disables the line noise filter
Set the line noise filter to use 2 columns
Set the line noise filter to use 4 columns
Set the line noise filter to use 8 columns
Set the line noise filter to use 16 columns
cs vbo [0-255] Sets the video black offset when the line noise filter is
enabled
cs active 0
1
Clears the sensor active signal to the CMOS image
sensor
Set the sensor active signal to the CMOS image sensor
PHOTONIS Digital Imaging LLC NVT 200-LC-4019
6170 Research Road Suite 208 Revision: C.04
Frisco, TX USA 75033 Page 21 of 39