Phonic WM-SYS3, Руководство пользователя

Страница: 9 / 26

9
WM-SYS3 / WM-SYS3D / WM-SYS4 / WM-SYS4D
WM70 TRANSMITTER
Front Panel
. Left and Right Sig/Clip Indicators
– the LED indicator will light up green
when a signal is being received by
the WM70 transmitter. It will change
to red when the signal level becomes
excessive, just 4dB before clipping.
. Trim Control – these controls adjust
the level of the signal received via
the Combo inputs on the rear that
will be sent wirelessly.
3. Channel Selector – adjusting this
dial to one of the preset channels
allows the WM70 to know which
frequency to send the wireless infor-
mation at. Each preset channel will
transmit both the left and right sig-
nals, so that the WM400(D)-L and
WM400(D)-R wireless receivers (if
set to the identical channel) will re-
ceive the signal successfully.
4. Stereo/Mono Selector – This will
allow users to change the wireless
signal sent from the WM70 to be al-
ternated between a mono and stereo
signal.
5. On/Off Button – this button turns
the WM70 on and off. An LED will il-
luminate under this button when it is
on.
Rear Panel
6. Left and Right Combo Input – this
jack accepts both balanced and un-
balanced /4” and XLR inputs from
line-level sources (such as the main
output of a mixer).
7. Left and Right Antennas – this for
the insertion of the WM70’s left and
right antennas. Insert the antennas
and adjust them to sit in a vertical
position when the device is in use.
Screw the antenna in to lock it into
place.
8. DC In – plug DC end of the supplied
DC power adaptor into this jack, and
the other end into a suitable AC pow-
er source to allow the WM70 to be
powered. Please ensure you use the
DC power supply (V, 750mA) pro-
vided with this unit, as using another
power supply could cause damage.