Phonic WM-SYS3, Руководство пользователя

Страница: 10 / 26

0
WM-SYS3 / WM-SYS3D / WM-SYS4 / WM-SYS4D
6
5 7
WM400(D) RECEIVERS
These wireless receivers can be used in
conjunction with any active speaker. The
receiver can be attached to the speaker
by screwing it into the stand’s screw
socket.
. 4 Digit Display (WM400D-L and
WM400D-R only) – This display will
allow users to see the properties that
are currently in use by the WM400D,
whether you are adjusting the receiv-
er channel (indicated by CH), the EQ
settings (indicated by EQ), the delay
time (indicated by only the delay time
in milliseconds) or the high and low
pass filters (indicated by a H or L, re -
spectively). This display will light up
when the device is turned on.
. AF Indicators – When this LED is
illuminated, it indicates that there is
an audio signal being received by
the WM400(D) receiver.
3. RF Indicators – When the RF indi-
cator illuminates, it shows that the
transmitter’s signal is being received
successfully. If for some reason this
LED does not turn on, check your
DC power input and pre-set channel
configuration and try again.
4. Bypass (WM400D-L and WM400D-
R only)– this LED will light up when
the digital processing feature of the
WM400D receiver is off.
5.
Power Button
– hold this button down
for seconds to power up the unit.
6. Bypass Button (WM400D-L and
WM400D-R only) – push this button
to turn the digital processing feature
on and off.
7. Up and Down Buttons (WM400D-L
and WM400D-R only) – these but-
tons are used to adjust the proper-
ties of various features built-into the
WM400D’s. Pushing up or down will
initially simply allow users to adjust
the channel that the transmitter is
using. If you push both of these but-
tons at the same time, it will jump to
the next setting that can be edited.
You can then adjust the properties
by pushing the up and down buttons.
These settings will come in the fol-
lowing order:
Channel Settings :
CH 0 – CH 9, CH A – CH F
Delay Settings :
0.0 – 300.0 milliseconds
EQ Mode :
P – P30 (see the EQ table for
a full rundown on EQ presets)
Low Cut Filter :
L 0 (Hz) – L (kHz)
High Cut Filter :
H 0 (kHz) – H 60 (Hz)
(High and low cut filters are adjusted in 1 Hz incre-
ments; 10Hz increments above 1kHz)
3 4
5 9