Operation
61-900040-000
Rev. Date:
01/22
3-29
3.10.1 Cleaning and Conditioning the Lanes
Table 3- 9 below lists the steps that should be performed to clean, oil, and buff a lane. Skip
any that do not apply to the operation being performed.
Startup Checklist
Table 3- 9
Move the machine from its storage location to the approach. Lower the machine to
the operating position and place on the starting lane.
Ensure the waste tank is empty. If not, remove the waste tank from the machine
and dispose of the used lane machine waste properly. Do NOT dump recovery
tank in a septic tank or sanitary sewer system. Follow your local environmental
regulations for the best method of disposal. Check the cleaner and oil tank levels.
If it is necessary to add cleaner or oil move the machine at least 3 feet (90 cm)
down the lane to avoid spillage on the approach. Do not add defoamer to machine
while on approach or lanes. Return machine to foul line when complete.
Plug the power cord into the appropriate electrical outlet.
Insert the large, blue plug into the power inlet on the machine and secure the cord to
the handle.
Press the POWER switch to ON.
Select the appropriate program for use.
Press the START button on the handle
once
.
When the START button is pressed the first time, the Phoenix LT4 performs the
following actions:
If running a routine that cleans the lanes, the spray head will begin spraying
solution onto the lane, the vacuum head drops to the lane, and the vacuum
motor starts.
If running a routine that only buffs or oils/buff the lanes, no action is taken.
Press the START button on the handle
a second time*
. The drive motor (and
buffer motor if oiling or buffing) starts and the machine begins to move down the
lane. If oiling, the transfer roller motor also starts.
*
The START button must be pressed a second time within five seconds of the
first push. If it is not pressed again, all operations will be cancelled.
Push the handle down (toward the approach) then release it to allow the machine to
travel down the lane.
As the Phoenix LT4 makes its forward and reverse pass on the lane to complete the
selected program, it performs the actions shown in Table 3- 10 on the following page. The
table separates each action by operation, but the Phoenix LT4 performs the actions
simultaneously when multiple operations are selected.
Содержание LT4
