Phoenix LT4 Lane Machine Operations, Maintenance, and Parts Manual
6-12
Rev. Date:
01/22
61-900040-000
800-937-2695). Additionally, Technical Support can be reached by e-mail at
[email protected] or via fax at 1-231-725-4667.
Table 6- 3
Dry spots in the oiled
area (from depressions,
undulating lane
surfaces, etc.)
If there are some dry spots
but
the rest of the lane has the
amount of oil desired, the buffer brush pressure should be
increased. This will not affect the amount of oil applied in the
rest of the oiled area.
If there are some dry spots
and
the rest of the lane does not
have the amount of oil desired, a second pass should be
added to the oiling program. If there still is not enough oil
being applied, the wicking foams may need to be replaced
with higher output foams or increase the transfer roller speed.
For information about this, refer to Section 6.5 -
Creating Oil
Output Patterns
. If changing the wicking foams does not
eliminate the problem, increase the buffer brush pressure.
For information about checking and testing the buffer brush,
refer to Section 4 -
Maintenance and Adjustments
.
Washboard or
Corrugated Pattern In
The Oiled Area
This indicates one of four things: the buffer brush pressure is
not consistent across the lane, the oil output is too low, the
buffer brush pressure needs to be increased, or the buffer
brush has been contaminated with grease due to improper
storage.
Test the buffer brush pressure across the entire width of the
brush. The pressure should be at the same point between B
and C on the Buffer Pressure Adjustment Tool at each place
tested on the buffer brush. If they are not, adjust the buffer
brush pressure until the pressure is the same across the width
of the brush. For information about measuring the pressure
and adjusting the buffer brush pressure, refer to Section 4 -
Maintenance and Adjustments
. Condition the lane after
making the adjustments to see if the problem has been
eliminated.
If the pressure is the same across the width of the brush and
the washboard or corrugated pattern occurs, check the amount
of oil applied to the lane. If more oil is desired, replace the
wicking foams with higher output foams. For information about
this, refer to Section 6.5 -
Creating Oil Output Patterns
.
Condition the lane after changing the wicking foams to see if
Содержание LT4
