7. Life phases
7.3 Important information on installation and putting into operation
It is essential that you note and observe the following instructions. Otherwise persons
could be injured or the electric cylinder or other components could be damaged.
•
•
No additional holes may be made in the electric cylinder.
This electric cylinder may only be used outdoors using the respective protective measures that are
defined by the factory order number.
The electric cylinder must be protected against the moisture, e.g., condensed water.
After setting up and putting into operation, it is essential that the plug of the power supply is
freely accessible.
The electric cylinder must not be moved to "Block". Risk of mechanical damage. The
electric cylinder must not be opened.
The user must ensure that there is no danger when the power supply is active.
When designing applications with this electric cylinder, take care to avoid crushing and shear
points. These must be respectively secured and marked.
Automatic start-up of the electric cylinder due to a fault is to be stopped immediately by
disconnecting the power supply.
If the supply line is damaged, the electric cylinder must be taken out of use immediately. The
push rod is secured against twisting using a red adhesive safety tape.
The adhesive safety tape must be removed during installation.
The push rod with fork head must be secured against twisting. Non-observance leads to the
adjustment of the stroke end position.
The electric cylinder has not been designed for continuous operation. The operating cycle per
hour determined for your application must not be exceeded.
•
•
•
•
•
•
•
•
•
•
•
•
44
