Phoenix Mecano DewertOkin DC20, Руководство по установке

Страница: 22 / 36

Installation DC20 Lifting Column
22 92299 1.0
6.2.2 Electrical connection
CAUTION
Electrical components should be connected or disconnected only when the mains
power plug and the battery plug (when present) are both unplugged.
Routing the electrical cables
When routing the cables, be sure that:

the cables cannot get jammed,

no mechanical load (such as pulling, pushing or bending) will be put on the cables, and

the cables cannot be damaged in any way.
Fasten all cables (especially the mains cable) to the end product using sufficient strain relief and
kink prevention methods. Be sure that the design of the end product prevents the mains cable from
coming into contact with the floor during transport.
6.2.3 Dismantling the DC20 lifting column
CAUTION
Electrical components should be connected or disconnected only when the mains
power plug and the battery plug (when present) are both unplugged.
CAUTION
Work on the DC20 lifting column while it is in its unloaded position. Only in this way can
you be sure to avoid any risks of crushing or injury.

Certain details may change because of technical changes.
1 Move your product into a position where it is supporting no load.
2 Remove the connecting cable from the controller or double drive.
3 If multiple drives are connected electrically, they should be disconnected from each other.
NOTICE
Support the DC20 lifting column; the DC20 lifting column is released immediately after
the screws are loosened.
4 Remove the DC20 lifting column from the end product.