Phoenix Mecano DewertOkin DC20, Руководство по установке

Страница: 19 / 36

DC20 Lifting Column Installation
92299 1.0 19
Avoiding an overrun of the stop point with the end product
Your end product should contain mechanical end stops. These will limit the drive movement and
significantly increase operational safety. DewertOkin recommends that you build such mechanical
end stops into your end product.
The DC20 lifting column has a safety switch.
 The safety end switch shuts the DC20 lifting column down as soon as the normal end switch is
passed over. The safety end switch is integrated directly into the DC20 lifting column and does
not require any additional installation.

The mechanical end stops or stroke limiters in the end product must be adjusted to fit the re-
tracted and extended dimensions of the DC20 lifting column. Make sure that the DC20 lifting
column does not reach the mechanical end stop position before it has been fully extended.
6.2 Installation procedure
NOTICE
Mount the DC20 lifting column in its unloaded position within your end product.
The DC20 lifting column must either be completely retracted or extended at its end position.
Damage to the DC20 lifting column can
only be avoided if it is installed in its unloaded position.
This ensures safe installation.
6.2.1 Installation
Before installing the lifting column, make sure that you are observing all of the safety notices found
in the "Safety notices to observe during installation" section.
CAUTION
The plug for the connecting cable should be unplugged during the installation.
Recommendations

The mounting plate of the end product should completely cover the cover plate of the DC20 lift-
ing column. Thus, make sure that the mounting plate is properly dimensioned.

The cable of the DC20 lifting column must be secured so that it cannot be pulled out.