SNMP Commands
8039_en_01
PHOENIX CONTACT
6-31
•
poe_fault: If the corresponding contact is enabled globally, it will open in case of PoE
failure event (only on MRP master!).
•
port_security: If the corresponding contact is enabled globally, it will open in case of an
not allowed MAC address detected at a protected port.
•
power_supply: If the corresponding contact is enabled globally, it will open in case of
failure of one Power Supply (US1 or US2).
SNMP C
OMMANDS
This section describes the commands you use to configure Simple Network Management
Protocol (SNMP) on the switch. You can configure the switch to act as an SNMP agent so that
it can communicate with SNMP managers on your network.
snmp-server
This command sets the name and the physical location of the switch, and the organization
responsible for the network. The range for
<name>
,
<loc>
and
<con>
is from 1 to 31
alphanumeric characters.
snmp-server community
This command adds (and names) a new SNMP community. A community
<name>
is a name
associated with the switch and with a set of SNMP managers that manage it with a specified
privileged level. The length of
<name>
can be up to 16 case-sensitive characters.
no snmp-server community
This command removes this community name from the table. The
<name>
is the community
name to be deleted.
Default
none
Format
snmp-server
{sysname <name> | location <loc> | contact <con>}
Mode
Global Config
Note:
Community names in the SNMP Community Table must be unique. When making multiple entries using the
same community name, the first entry is kept and processed and all duplicate entries are ignored.
Default
•
Public and private, which you can rename.
•
Default values for the remaining four community names are blank.
Format
snmp-server community
<name>
Mode
Global Config
Format
no snmp-server community
<name>
Mode
Global Config
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx