Management Commands
8039_en_01
PHOENIX CONTACT
6-1
S e c t i o n 5 : M a n a g e m e n t C o m m a n d s
This chapter describes the management commands available in the FL SWITCH GHS
Firmware CLI.
N
ETWORK
I
NTERFACE
C
OMMANDS
This section describes the commands you use to configure a logical interface for
management access. To configure the management VLAN, see
“network mgmt_vlan” on
page 20
enable (Privileged EXEC access)
This command gives you access to the Privileged EXEC mode. From the Privileged EXEC
mode, you can configure the network interface.
serviceport ip
This command sets the IP address, the netmask and the gateway of the network
management port.
serviceport protocol
This command specifies the network management port configuration protocol. If you modify
this value, the change is effective immediately. If you use the
bootp
parameter, the switch
periodically sends requests to a BootP server until a response is received. If you use the
dhcp
parameter, the switch periodically sends requests to a DHCP server until a response is
received. If you use the
none
parameter, you must configure the network information for the
switch manually.
Caution!
The commands in this chapter are in one of three functional groups:
•
Show commands display switch settings, statistics, and other information.
•
Configuration commands configure features and options of the switch. For every configuration command,
there is a show command that displays the configuration setting.
•
Clear commands clear some or all of the settings to factory defaults.
Format
enable
Mode
User EXEC
Format
serviceport ip
<ipaddr> <netmask> [gateway]
Mode
Privileged EXEC
Format
serviceport protocol
{none | bootp | dhcp}
Mode
Privileged EXEC
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx