AXL F SSDO8/3 1F
30
PHOENIX CONTACT
106888_en_01
4.1.3
Setting the DIP switch
A DIP switch is located on the top of the module.
Figure 4-1
DIP switch
12-pos. DIP switch:
address and operating
mode
Set the SafetyBridge address and the operating mode via the 12-pos. DIP switch.
Overview of the switch
positions
Setting the address
•
Remove the marking field and set the address in the switch below it.
•
Reattach the marking field to the module.
CM| Island | Satellite
off
on
11
10
9
8
7
6
5
4
3
2
1
0
S1
Table 4-1
Switch position
Operating
mode
Reserved
SafetyBridge address
CM
Island number
Satellite number
11
10
9
8
7
6
5
4
3
2
1
0
off/on
on
1
dec
to 31
dec
1
dec
to 16
dec
Switch 0 to 9:
SafetyBridge address (island number)
Switch 10:
Reserved Always
on
Switch 11:
Operating
mode
off
= SafetyBridge mode
on
= startup mode
Position 10 of the 12-pos. DIP switch is reserved and must always be in the “on” position.
Otherwise, the module responds with a failure state.
The set address is only applied on power up. If the address is adjusted during operation,
the module responds with a failure state.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from