Phoenix Contact 1212463, Руководство по эксплуатации

Страница: 17 / 36

Troubleshooting
105555_en_07 PHOENIX CONTACT
17
English
3.1 Overview of possible faults
Error Cause Solution
The device will not switch on – Problems with the power supply – Check the battery
– Clean the battery compartment
The green indicator light
flashes, but the device does
not trip or the conductor can-
not be inserted
– The battery was removed during a crimp-
ing cycle
– Problems with the power supply
– The conductor is not recognized
– The crimping unit has been shifted manu-
ally
– Initialize device (see Page 26)
The green indicator light
flashes, but there is still a con-
ductor in the device
– The conductor was not correctly prepared
(see Page 14)
– The conductor was inserted with too
much force
– The conductor was pulled out too early
– The conductor does not correspond to the
specifications
– Carefully turn the conductor and pull
it out
– The battery was removed during the
crimping process
– Screw in the service tool and re-
move the conductor
– Then initialize device (see Page 26)
The green and red indicator
lights flash slowly, but the con-
ductor is correct
– The conductor is not recognized
– The conductor is recognized as having an
incorrect cross-section
– Switch off the device without the
conductor, and then switch on again
– Check the stranding of the wires
– Check if the conductor corresponds
to the specifications
– Check the temperature range
Errors re-occur several times – The conductor does not correspond to the
specifications
– Check if the conductor corresponds
to the specifications
– Wear of the stripping blade
Indications for wear of the blade are rough
and asymmetrical cut edges on the insu-
lation remnants in the waste container
– Please contact Phoenix Contact
– The conductor was not correctly prepared
(see Page 14).
– Prepare the conductor according to
specifications