Mechanical Instructions
EN 18
SDI PDP 2K7
4.
4.1.8
Exchange YB and YM board - 42” HD W2 & 42” HD W2 Plus
1.
Unplug all of the FPC connectors of Y-B. See “Photo 1”.
2.
Loosen all the screws of Y-Buffer and Y-Main.
3.
Remove the board from the chassis.
4.
Unplug connectors CN5001, CN5002, CN5006 and
CN5003 between Y-Buffer and Y-Main. See “Photo 2”.
5.
Remove Y-Buffer from the Y-main.
6.
Replace the defective board.
7.
Re-assemble Y-Buffer to the Y-Main.
8.
Plug in connectors CN5001, CN5002, CN5006 and
CN5003 between Y-Buffer and Y-Main.
9.
Arrange the boards on the chassis and tighten them.
10. Connect the FPC connectors.
11. Supply the electric power to the module and then check the
waveform of the board.
12. Turn “off” the power after the waveform is adjusted.
Figure 4-21 Photo 1 and 2: Dis-assembly of YB and YM board - 42” HD W2 & 42” HD W2 Plus
H_16870_029.eps
020407